Link-Belt field tests and introduces TCC-2500 in same week

22 May 2017


The all new Link-Belt TCC-2500 was already hard at work the same week Link-Belt Cranes formally introduced the crane world to the 250-ton telescopic crawler crane at ConExpo-Con/Agg 2017 in Las Vegas, NV. L.R. Willson and Sons, Inc. of Gambrills, MD is field testing the TCC-2500, completing tilt-panel work and steel erection for a 38,000 square foot warehouse in the Washington, D.C. suburb of Capitol Heights, MD. A 13,000 pound spreader bar and six parts line were used to place panels weighing as much as 84,000 pounds.

“The crane is very smooth. It picked up the largest panels at a 35.4 footradius, with a 68 degree boom angle, and we were good up to 123,000 pounds,” said operator Jamie Foster, L.R. Wilson and Sons, Inc. In total, the company set 38 precast tilt-up panels over a seven day period before moving on to steel erection for the interior of the building. The company normally uses a lattice boom crane to erect panels of this size, but in light of the new design and capacity of the TCC-2500, the company welcomed the chance to prove the machine’s capability.

“This machine is a beast, and I cannot think of a better way to test our design and the functionality of this crane than with pour-in-place tilt wall work. Based on early comments I think we have hit a home run,” said Scott Knight, Link-Belt product manager, lattice and telescopic crawler cranes.

Check out the TCC-2500 hard at work below.



Receive the information you need when you need it through our world-leading magazines, newsletters and daily briefings.

Sign up